New from Radium - the Fuel Pump Hanger for 2011+ Ford Mustangs. This hanger can be configured multiple ways to suit any fuel demand up to 1,500HP. See more details below.

Official Release:

A top of the line drop-in fuel pump solution for the S197 and S550 Mustangs is now available! The Radium Engineering fuel pump hanger for 2011+ Mustangs can be configured multiple ways to suit any fuel demand.

Making more horsepower with a modified Ford requires more fuel to be sent to the engine. The Radium fuel pump hanger increases the pump capability while offering other advantages as well. The hanger drops right into the OEM fuel tank and can be configured to use one or two aftermarket high-flow pumps, able to supply up to 1,500HP worth of fuel.

As with other Radium in-tank hangers, this one includes a venturi jet pump that has been specially designed to operate with high flow pumps without causing high back pressure in the return line. The venturi jet pump uses the fuel returning from the regulator to create suction which draws fuel from the opposite side of the fuel tank. The return fuel and the suction fuel is then deposited into the collector box where the pump inlets are located. This system ensures there is always ample fuel around the fuel pump inlets.

The collector box encapsulates the complete fuel pump hanger and keeps fuel trapped around the pumps. Fuel is allowed to enter, but not exit, via the one-way check ball port. The fuel pump hanger re-uses the factory level sender, which installs on to the back side of the hanger bracket. All wire pass throughs are done with electrical studs that are fully insulated and sealed.

The CNC machined aluminum top plate is designed to be low profile and fit under the factory fuel pump cover. The output port is -8AN ORB female and includes an adapter fitting to convert to -8AN male for connection of aftermarket high flow fuel lines. The return port is machined for -8AN ORB female and an adapter is included for -6AN male.

The fuel hanger kit includes all the hardware, fittings and pieces shown above for a complete installation. It can be purchased pre-assembled with pumps, or without pumps included. As with all Radium Engineering products, this item is compatible with all fuel types including E85.

Features:

  • Anodized Aluminum Laser Etched Plate
  • Anodized Aluminum Collector Box and Check Valve
  • Anodized Aluminum Venturi Jet Pump with Multiple Orifices
  • Anodized Aluminum 8AN Male Outlet Fitting
  • Anodized Aluminum 6AN Male Inlet Fitting
  • Anodized Aluminum Dual Pump Cradle
  • PTFE Wire with Stainless Steel Terminals
  • Fluorosilicone Duckbill Return Valve
  • Stainless Steel Hardware and Clamps