2003 Cobra Puts Down 884 Horsepower Through An Auto

When your engine serves you an oil milkshake, you have two choices pour it out and start over or mix in some new flavor and rebuild. Jon Pavia opted not just to rebuild but to make his 2003 Cobra stronger and faster. We detailed his revamped engine in two stories here (Part 1 and Part 2), and his new combo recently hit the Dynojet at VMP Performance with some impressive results.

Jon Pavia recently ramped up this VMP TVS-supercharged Terminator with a built engine based on a Teksid aluminum modular block. He now hopes to put his Cobra into the 8-second zone.

Jon Pavia recently ramped up this VMP TVS-supercharged Terminator with a built engine based on a Teksid aluminum modular block. He now hopes to put his Cobra into the 8-second zone.

That engine made 608 horsepower through a 4R70W auto with an unlocked converter and 725 horsepower with a 100 shot.

“Previously, I ran my car with the stock iron block, Manley platinum pistons and 9.5:1 compression. I built that engine myself as well and it ran great for several years. I pushed that engine extremely hard at multiple NMRA events,” he said. “That engine made 608 horsepower through a 4R70W auto with an unlocked converter and 725 horsepower with a 100 shot. Then, one day I drained the oil to do an oil change and it was nothing but a milkshake. I knew the engine had to come out and after further investigation; the cylinder wall between number 3 and number 4 was cracked all the way to the mains.”

As a refresher, we detailed the first and second parts of that build Jon picked up one of the storied early modular aluminum blocks. Cast in Italy by Teksid, these 1999-earlier blocks are noted for holding up to big power, while saving weight versus the monolithic iron block Terminators were born with.

Jon’s previous combo made 720 at the wheels on just boost from the VMP Gen2 TVS supercharger (PN COBRATVS; $3,399). The new engine combo with the same blower jumped up to 754-rear-wheel horsepower on boost.

Jon’s previous combo made 720 at the wheels on just boost from the VMP Gen2 TVS supercharger (PN COBRATVS; $3,399). The new engine combo with the same blower jumped up to 754-rear-wheel horsepower on boost.

“I built the engine myself and it’s been a ‘work in progress’ for the last year and a half. It’s a Teksid block with my stock ’03 Cobra crank, Manley H-beams and a set of Gibtec billet pistons,” Jon explained. “The pistons I chose put me right at 10.5:1 compression. The heads were previously ported from the last engine so this time I sent them to Total Engine Airflow for a complete overhaul (new intake/exhaust valves, springs, exhaust seats, guides). A set of custom grind Bullet cams spec’d by Todd Warren topped off the engine.”

Jon Pavia 2003 Cobra Mods

• Cobra Engineering oil cooler delete, rear cooling mod, secondary timing tensioner

• Metco Motorsports pulleys

• Viking Performance coilovers (front and rear)

• VMP Gen2 TVS w/ GT500 throttle body

• UPR K-member

• UPR Extreme Series rear suspension

As you can see in the video above, Jon recently rocked the rollers on the Dynojet at VMP Performance to the tune of 754 rear-wheel horsepower on just boost. With a 100-shot of nitrous on to, his VMP TVS-supercharged Terminator put down 884 to the tires. Now, he hopes to put that power to work at the drag strip.

“Previously, the car went 9.29 in the quarter mile with a 1.26 60-foot on UPR suspension and Viking coilovers,” Jon added. “With the added horsepower, a TH400 trans and full line of UPR/Viking suspension, my goal is to run in the eights and set the record for the fastest ’03-’04 Cobra with a TVS.”

With that huge jump in performance and cooler weather heading to Florida where he is based, we’d say Jon has a good shot at reaching his goal in the near future.

Topping of the VMP-blown 4.6-liter engine with a 100-horsepower hit of nitrous pushed the rear-wheel output to 884 ponies—through a Turbo 400 automatic transmission!

Topping of the VMP-blown 4.6-liter engine with a 100-horsepower hit of nitrous pushed the rear-wheel output to 884 ponies—through a Turbo 400 automatic transmission!

Article Sources

About the author

Steve Turner

Steve Turner brings decades of passion and knowledge in the world of Ford performance, having covered it for over 20 years. From the swan song of the Fox Mustang to the birth of the Coyote, Steve had a front-row seat.
Read My Articles

Blue Oval Muscle in your inbox.

Build your own custom newsletter with the content you love from FordMuscle, directly to your inbox, absolutely FREE!

Free WordPress Themes
FordMuscle NEWSLETTER - SIGN UP FREE!

We will safeguard your e-mail and only send content you request.

Ford Muscle - The Ultimate Ford Mustang Magazine

FordMuscle

We'll send you the most interesting FordMuscle articles, news, car features, and videos every week.

Ford Muscle - The Ultimate Ford Mustang Magazine

FordMuscle NEWSLETTER - SIGN UP FREE!

We will safeguard your e-mail and only send content you request.

Ford Muscle - The Ultimate Ford Mustang Magazine

Ford Muscle

Thank you for your subscription.

Subscribe to more FREE Online Magazines!

We think you might like...


Muscle Car & Hot Rods
Muscle Car & Hot Rods
Drag Racing
Drag Racing

Ford Muscle - The Ultimate Ford Mustang Magazine

Thank you for your subscription.

Subscribe to more FREE Online Magazines!

We think you might like...

  • Muscle Car & Hot Rods Muscle Car & Hot Rods
  • Drag Racing Drag Racing

Ford Muscle - The Ultimate Ford Mustang Magazine

Ford Muscle

Thank you for your subscription.

Thank you for your subscription.

Ford Muscle - The Ultimate Ford Mustang Magazine

Thank you for your subscription.

Thank you for your subscription.

Loading